• date_rangePosted On :   Aug 18' 2007
• location_cityCity :   Skive
• languageCountry :   Denmark
• content_pasteEnquiry No. :   7081826

Looking for a PMDC electric motor with the following
specifications:
Supply Voltage: 24VDC
Power: minimum 700W-Maximum 900W
Max length (not including output shaft) 150mm.
Max Diameter: 100mm
End Mounting by screws through shaft end plate (NO side
mounting brackets)
Output RPM approximately 2000-3000 RPM at 24VDC
Output shaft length minimum 15mm
Output shaft diameter 10mm
NO gears.
Also looking for a PMDC Gear motor, with the following
specifications:
Supply Voltage 24VDC
Power: minimum 100W, Maximum 150W.
Max diameter 65mm. No max length.
Output shaft diameter 10mm.
Output speed minimum 600RPM maximum 1200RPM. No Plastic Gears
Accepted-Only Metal Gears.
End mounting at output shaft end only.
If you have a motor which you think may fit these then please
send me a pdf file with the specifications. Do not ask me to
visit your web site-I do not do so. If I visited the web sites
of all those who asked, I could not do anything else all day.
Also note: I do not have a sample to send, I am looking for
motors which already exist for a very new design I am
working on.
Regards